Jotul GF 400 DV Bedienungsanleitung PDF herunterladen (Seite 18)

Gas Supply Connection

Connect the gas supply line to the stove, before

installing the optional Blower.

If the blower will be installed, use a 45° elbow off the

control valve to create clearance required for the blower

installation.

The gas supply line connection is made to the left side of

the valve. The gas supply line should be 3/8" npt with a

1/2" diameter supply, or the appropriate size to provide

sufficient gas pressure to the valve regardless of the

input setting.

The use of Flexible Gas Appliance Connectors is

acceptable in many areas in the U.S. However, Canadian

methods vary depending on local code.

ALL INSTALLATIONS MUST COMPLY WITH LOCAL

CODE OR IN THE ABSENCE OF LOCAL CODE, MUST

COMPLY WITH THE MOST RECENT EDITION OF THE

NATIONAL FUEL GAS CODE ANSI Z223.1/NFPA 54 OR

CAN-B149.

All codes require a gas shut-off valve (gas cock) and

union, to be installed in the supply line, and in the same

room as the appliance. This allows for the disconnection

of the stove for servicing and maintenance. See fig. 27.

Figure 27. Supply valve coupling.

Pilot Head

Orifice

Retainer

Clip

Pilot Base

Figure 25. Pilot orifice removal and replacement.

14. Remove the Regulator Tower, Gasket, white plastic

disk, and Spring.

15. Install the new regulator: Be sure the new gasket is

properly positioned and tighten screws securely.

16. Install the identification labels to the stove so that they

can be seen by any person that may be servicing the stove.

Label A: apply to back of stove.

Label B: apply to stove’s rating plate.

Small valve Label: apply to valve.

17. Reassemble the stove, apply gas to the system and

check for leaks using a soapy water solution.

18. Adjust the Air Shutter:

CAUTION! USE WORKGLOVES. SURFACES MAY BE HOT!

You will need to adjust the shutter to the position

that supplies the correct amount of air mixture to

achieve the best flame picture with your particular

installation. Start with the shutter stem at the

midway position in the slot in the bottom of the

stove. See fig. 21. Pushing the stem back will restrict

air, while pushing it forward will open the shutter.

Too much air will produce a lighter flame, while too

little will promote long, dark flames and may pro-

mote sooting. Make adjustments in small incre-

ments. With some experimentation, you will find the

shutter position that works best for your installation.

Figure 26. Regulator assembly.

Apply small

label here

Remove black

gasket

Regulator

Tower

NEVER USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.

Correct gas pressure is essential for efficient and safe

operation of this appliance. Correct gas pressure

must be established at the time of installation. For

more details, see the Gas Pressure section of this

manual (page 19).

ALWAYS REFER TO THE LIGHTING INSTRUCTIONS ON THE

INSIDE BACK COVER OF THIS MANUAL WHEN LIGHT-

ING YOUR STOVE.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Jotul GF 400 DV Bedienungsanleitung Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kamine Jotul GF 400 DV