Jotul GF 400 DV Bedienungsanleitung PDF herunterladen (Seite 25)

Optional Blower # 156000

Figure 43. Attach Snapstat and Blower Brackets.



 THIS BLOWER MUST BE ELECTRICALLY

GROUNDED IN ACCORDANCE WITH

LOCAL CODES OR, IN THE ABSENCE OF

LOCAL CODES, WITH THE CURRENT

ANSI/NFPA 70, NATIONAL ELECTRICAL

CODE OR CSA C22.1-CANADIAN

ELECTRICAL CODE.



 THIS UNIT IS SUPPLIED WITH A

THREE-PRONG (GROUNDING) PLUG

FOR PROTECTION AGAINST SHOCK

HAZARD AND SHOULD BE PLUGGED

DIRECTLY INTO A PROPERLY

GROUNDED THREE-PRONG

RECEPTACLE. DO NOT CUT OR

REMOVE THE GROUNDING PRONG

FROM THE PLUG.



 ALWAYS DISCONECT THE POWER

SUPPLY WHEN PERFORMING ANY

SERVICE ON THE FIREPLACE INSERT.

Connect the gas supply line to the stove,

before installing the Blower.

Use a 90° Elbow off the control valve to create

clearance required for the blower installation.

1. Unpack and check the contents of the blower kit.

Contact your dealer if any damage is evident or

parts are missing. See fig. 42.

2. Attach the Snapstat Bracket to the studs located in

the middle of the firebox floor using the two M6

hex nuts and a 10 mm wrench. See fig. 43.

3. Attach the Blower Bracket to the stove using the

two M6 flange head hex bolts as shown in fig. 43.

4. Attach the Duct Deflectors using the two #7 x 1/2”

screws together with the finger guard mounting

screws already in place. See #7 and #11 in fig. 42.

5. Install the Blower with the duct openings oriented

up and forward. See fig. 44. Feed the wire harness

through the bracket opening and secure the blower

to the bracket with the wingscrew.

6. Attach either Snapstat wire connector to either

Snapstat terminal. See fig. 44.

7. Install the Snapstat by sliding it all the way into the

slot in the bottom of the Snapstat Bracket as shown

in figs. 42 and 44.

8. Connect the male wire harness connector to the

female wire harness connector already installed in

the stove. See fig. 44.

9. Connect power cord to outlet.

Snapstat

Bracket

Blower Bracket

Hex Head

Flange Bolts

Hex Head

Flange Nuts

Figure 42. Blower Kit Components

Contents

1. Blower

2. Mounting Bracket

3. Snapstat Wire Harness

4. Control Switch Wire Harness

5. Snapstat

6. Snapstat Bracket

7. Blower Duct Deflector (2)

8. M6 Hex Head Flange Nuts (2)

9. M6 x 12 Hex Head Flange Bolts (2)

10. M6 x 12 Wingscrew

11. #7 x 1/2” phillips screw (2)

Tools Required

• 10 mm wrench

* short phillips screwdriver

* Safety Glasses

* Work Gloves

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Jotul GF 400 DV Bedienungsanleitung Seite 25

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kamine Jotul GF 400 DV